.FSR E 2013 WORLD CHAMPION 2013....

Hull for the winner .....

Boat - WORLD CHAMPION 2013 CLASS FSR E !!!

It was in the city of Gent, in Belgium, in August 2013
So simply and casually ..
This is the start of the finals. Our boat is light green:

Today this body the most productive in the class FSR E - 77 laps in the full-race (8 boats in ine race). The closest competitors result -70 laps ...
The result achieved on our boat - do not show no one! And not even close to chosen ....
The main difference between our boat from the other - the existence of remote-controlled Flaps! Plates (angle of deviation from the bottom) are controlled by a servo of the third channel of your transmitter.

Tehnical hull characteristics:

Length: 600 mm
Width: 240mm
Height: 91 mm

The boat set:
Gelmport,
Flaps with the system change their angle by the servo (servo just installed.)
Rudder with tiller and ball joints for the servo.
Steering servo Hitec 81.
Power circuit breaker (a requirement of the rules).
By wiring the power cable cross-section 3.35 mm square.
Motor mounts.
Shaftline, with the propeller shaft and couplings under the motor.
Tubes fence - water discharge to water cooling circuit (included with the boat supplied 1 meter silicone tubing).
Cut all the necessary holes under input - water output in the flooded compartment.

This boat is perfectly suitable for participation in the class ECO EXPERT !!

Adjusting longitudinal stability using Flaps - simplified and made shorter, Your Way at Victory !!